СИСТЕМА МЕХАНИЧЕСКОЙ ТРАНСМИССИИ "MULTIMODE" Shift Lock Solenoid Circuit

DESCRIPTION

The shift lock solenoid is built into the shift lock control unit assembly. When the ignition switch is off, or when the shift lever is in N without depressing the brake pedal although the ignition switch is ON, the shift lock solenoid restricts the shift lever movement.

The TCM sends the shift lock cancellation signal to the shift lock solenoid to cancel the shift lock when the multi-mode manual transaxle system conditions are satisfied.

WIRING DIAGRAM

A012I2PE01

PROCEDURE

  1. INSPECT SHIFT LOCK CONTROL UNIT ASSEMBLY (SHIFT LOCK SOLENOID)

    1. Disconnect the shift lock control unit assembly connector.

      A012KTUC02
      *a

      Component without harness connected

      (Shift Lock Control Unit Assembly)

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      2 (IG) - 6 (E) 20°C (68°F) 30 to 35 Ω
      Result
      Proceed to
      OK
      NG
    NG

    REPLACE SHIFT LOCK CONTROL UNIT ASSEMBLY Click hereНажмите здесь


    OK
  2. CHECK HARNESS AND CONNECTOR (SHIFT LOCK SOLENOID - TCM, BODY GROUND)

    1. Disconnect the TCM connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      E104-5 (SLS) - E103-2 (IG) Always Below 1 Ω
      E103-6 (E) - Body ground Always Below 1 Ω
      E104-5 (SLS) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG
    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR


    OK
  3. INSPECT TCM

    1. Reconnect the TCM connector.

    2. Reconnect the shift lock control unit connector.

    3. Turn the ignition switch to ON.

      A012FN0C12
      *a

      Component with harness connected

      (TCM)

    4. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      E104-5 (SLS) - Body ground Brake pedal depressed 11 to 14 V
      Brake pedal released Below 1 V
      Result
      Proceed to
      OK
      NG
    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here Нажмите здесь


    NG
  4. REPLACE TCM

    1. Replace the TCM.

      for LHD: Click here Нажмите здесь

      for RHD: Click here Нажмите здесь

      Result
      Proceed to
      NEXT
    NEXT
  5. PERFORM INITIALIZATION

    1. Perform the initialization and learning procedure.

      Click hereНажмите здесь

      Result
      Proceed to
      NEXT
    NEXT

    END