МЕХАНИЧЕСКАЯ ТРАНСМИССИЯ "MULTIMODE" В СБОРЕ СНЯТИЕ

CAUTION / NOTICE / HINT

Note:

When the multi-mode manual transaxle assembly is removed, be sure to use a new clutch release with bearing cylinder assembly and new installation bolts. Removal of the transaxle allows the compressed clutch release with bearing cylinder assembly to return to its original position. Dust from the moving section may damage the seal of the clutch release with bearing cylinder assembly, possibly causing clutch fluid leaks.

PROCEDURE

  1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

    Click here Нажмите здесь

  2. REMOVE FRONT ENGINE MOUNTING INSULATOR

    Click here Нажмите здесь

  3. REMOVE REAR ENGINE MOUNTING INSULATOR

    Click here Нажмите здесь

  4. REMOVE NO. 1 AIR TUBE

    1. Disconnect the wire harness clamp.

      A012K7VC01
      *a Hose Clamp
    2. Remove the 4 bolts.

    3. Loosen the hose clamp and remove the No. 1 air tube.

  5. REMOVE STARTER ASSEMBLY

    Click hereНажмите здесь

  6. DISCONNECT WIRE HARNESS

    1. Disconnect the 2 connectors from the select stroke sensor and park/neutral position switch assembly.

      A012JQU
    2. Disconnect the 3 clamps and remove the wire harness.

    3. Disconnect the 2 clamps.

      A012GG0
    4. Remove the nut and bolt, and disconnect the wire harness from the multi-mode manual transaxle assembly.

  7. REMOVE MULTI-MODE MANUAL TRANSAXLE ASSEMBLY

    1. Remove the 8 bolts and multi-mode manual transaxle assembly.

      A012INH
  8. REMOVE ENGINE MOUNTING BRACKET LH

    1. Remove the 4 bolts and engine mounting bracket LH.

      A012GWYC01
      *A Type A
      *B Type B
  9. REMOVE FRONT ENGINE MOUNTING BRACKET

    1. Remove the 4 bolts and front engine mounting bracket.

      A012HYH
  10. REMOVE REAR ENGINE MOUNTING BRACKET

    1. Remove the 4 bolts and rear engine mounting bracket.

      A012L8V
  11. REMOVE CLUTCH ACTUATOR ASSEMBLY

    Click here Нажмите здесь

  12. REMOVE NO. 1 CLUTCH ACTUATOR BRACKET

    1. Remove the 4 bolts and No. 1 clutch actuator bracket from the multi-made manual transaxle assembly.

      A012KFG
  13. REMOVE CLUTCH RELEASE BLEEDER SUB-ASSEMBLY

    Click hereНажмите здесь

  14. REMOVE CLUTCH RELEASE WITH BEARING CYLINDER ASSEMBLY

    Click hereНажмите здесь

  15. REMOVE CLUTCH RELEASE CYLINDER TO BLEEDER TUBE

    Click hereНажмите здесь

  16. REMOVE WIRE HARNESS CLAMP BRACKET

    1. Remove the 3 bolts and 3 wire harness clamp brackets.

      A012GLM
  17. REMOVE SPEEDOMETER DRIVEN HOLE COVER SUB-ASSEMBLY

    1. Remove the bolt and speedometer driven hole cover sub-assembly from the transaxle case.

      A012MJU
    2. Remove the O-ring from the speedometer driven hole cover sub-assembly.