СИСТЕМА СЦЕПЛЕНИЯ (для моделей с EA66) ПРОКАЧКА

CAUTION / NOTICE / HINT

Note:

Wash off clutch fluid immediately if it comes in contact with any painted surface.

Tip:
  • If any work is performed on the clutch system or if air in the clutch lines is suspected, bleed the air from the clutch hydraulic system.

  • In case of clutch fluid replacement, make sure that the old fluid is replaced in the clutch line between reservoir and bleeder before bleeding.

PROCEDURE

  1. FILL RESERVOIR WITH BRAKE FLUID

    Click here Нажмите здесь

  2. BLEED CLUTCH LINE

    1. Remove the bleeder plug cap.

      A012M7A
    2. Connect a vinyl tube to the bleeder plug.

    3. Depress the clutch pedal 5 times, and then loosen the release cylinder bleeder plug while the pedal is depressed.*1

    4. When fluid no longer comes out, tighten the release cylinder bleeder plug, and then release the clutch pedal.*2

    5. Repeat steps *1 and *2 until all the air in the brake fluid is completely bled out.

      Note:

      Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while replacing the brake fluid.

    6. Check that all the air has been bled from the clutch line.

    7. Tighten the release cylinder bleeder plug.

      Момент затяжки
      8.4 N*m  { 86 kgf*cm, 74 in.*lbf }
    8. Depress the clutch pedal 10 times or more and confirm its operation.

      Note:

      This must be performed before the engine is started.

    9. Install the bleeder plug cap.

      A012M7A
  3. INSPECT BRAKE FLUID LEVEL IN RESERVOIR

    Click here Нажмите здесь