ПРИВОД СЦЕПЛЕНИЯ (для EC65A) УСТАНОВКА

PROCEDURE

  1. INSTALL CLUTCH ACTUATOR ASSEMBLY

    A012I48N01
    1. Temporarily tighten the bolt A.

      Note:

      Support the clutch actuator assembly until all 3 bolts are tightened.

    2. Install the bolt B.

      Момент затяжки
      17 N*m  { 173 kgf*cm, 13 ft.*lbf }
    3. Install the bolt C.

      Момент затяжки
      17 N*m  { 173 kgf*cm, 13 ft.*lbf }
    4. Fully tighten the bolt A.

      Момент затяжки
      17 N*m  { 173 kgf*cm, 13 ft.*lbf }
    5. Using a 10 mm union nut wrench, install the bleeder clutch release tube.

      A012F6E
      Момент затяжки
      15.2 N*m  { 155 kgf*cm, 11 ft.*lbf }
      Note:
      • Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).

      • Use the torque value compensation formula to calculate the torque value for use when a torque wrench is combined with a tool such as a union nut wrench.

        Click hereНажмите здесь

    6. Connect the wire harness with the bolt.

      Момент затяжки
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }
    7. Connect the clutch motor assembly connector.

    8. Connect the clutch stroke sensor connector.

  2. INSTALL NO. 2 BATTERY CARRIER

    Click hereНажмите здесь

  3. INSTALL BATTERY

    Click hereНажмите здесь

  4. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

    Click hereНажмите здесь

  5. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

    Click hereНажмите здесь

  6. INSTALL NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

    Click hereНажмите здесь

  7. INSTALL NO. 1 ENGINE UNDER COVER

    Click hereНажмите здесь

  8. BLEED CLUTCH LINE

    Click hereНажмите здесь

  9. PERFORM INITIALIZATION OF MULTI-MODE MANUAL TRANSMISSION SYSTEM

    Click hereНажмите здесь

  10. PERFORM LEARNING OF MULTI-MODE MANUAL TRANSMISSION SYSTEM

    Click hereНажмите здесь

  11. INSPECT FOR FLUID LEAK

    Tip:

    Check for leaks in the clutch system.