БЛОК МЕХАНИЧЕСКОЙ ТРАНСМИССИИ "MULTIMODE" ПРОВЕРКА

PROCEDURE

  1. INSPECT REVERSE IDLER GEAR SUB-ASSEMBLY

    1. Using a caliper gauge, inspect the reverse idler gear sub-assembly.

      A012FV1
      Standard Inside Diameter
      25.056 to 25.074 mm (0.98645 to 0.98716 in.)
      Maximum Inside Diameter
      25.074 mm (0.98716 in.)

      If the inside diameter exceeds the maximum, replace the reverse idler gear sub-assembly.

    2. Using a micrometer, inspect the reverse idler gear shaft.

      Standard Outer Diameter
      24.984 to 25.000 mm (0.98362 to 0.98425 in.)
      Minimum Outer Diameter
      24.984 mm (0.98362 in.)

      If the outer diameter is less than the minimum, replace the reverse idler gear shaft.