ДАТЧИК СОСТАВА ТОПЛИВОВОЗДУШНОЙ СМЕСИ СНЯТИЕ

PROCEDURE

  1. REMOVE OUTER COWL TOP PANEL

    Tip:
  2. REMOVE NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

    Click here Нажмите здесь

  3. REMOVE NO. 2 ENGINE COVER BRACKET (w/ No. 1 Engine Cover)

    1. Remove the 2 nuts and No. 2 engine cover bracket.

      A012K8H
  4. REMOVE WIRE HARNESS CLAMP BRACKET

    1. w/ No. 1 Engine Cover

      A012HTH
      1. Disconnect the connector from the air fuel ratio sensor.

      2. Disengage the 5 clamps and disconnect the wire harness from the wire harness clamp bracket.

      3. Remove the wire harness clamp bracket.

    2. w/o No. 1 Engine Cover

      A012FF6
      1. Remove the nut.

      2. Disconnect the connector from the air fuel ratio sensor.

      3. Disengage the 5 clamps and disconnect the wire harness from the wire harness clamp bracket.

      4. Remove the wire harness clamp bracket.

  5. REMOVE AIR FUEL RATIO SENSOR

    1. Using SST, remove the air fuel ratio sensor from the exhaust manifold converter sub-assembly.

      A012I5LE03
      SST
      09224-00010
      Note:

      If a component has been dropped or subjected to a strong impact, replace it.