ДАТЧИК ПОЛОЖЕНИЯ РАСПРЕДВАЛА УСТАНОВКА

PROCEDURE

  1. INSTALL NO. 1 CRANK POSITION SENSOR (w/ Stop And Start System)

    1. Apply a light coat of engine oil to the O-ring of the No. 1 crank position sensor.

      A012JYCC01
      *1 O-ring
      Note:

      If reusing the No. 1 crank position sensor, be sure to inspect the O-ring.

    2. Install the No. 1 crank position sensor onto the timing chain cover sub-assembly with the bolt.

      Момент затяжки
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }
      Note:
      • If a component has been dropped or subjected to a strong impact, replace it.

      • Make sure that the O-ring is not damaged or does not jump out of position during installation.

    3. Connect the connector to the No. 1 crank position sensor.

  2. INSTALL NO. 1 CRANK POSITION SENSOR (w/o Stop And Start System)

    1. Apply a light coat of engine oil to the O-ring of the No. 1 crank position sensor.

      A012JACC01
      *1 O-ring
      Note:

      If reusing the No. 1 crank position sensor, be sure to inspect the O-ring.

    2. Install the No. 1 crank position sensor onto the cylinder head cover sub-assembly with the bolt.

      Момент затяжки
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }
      Note:
      • If a component has been dropped or subjected to a strong impact, replace it.

      • Make sure that the O-ring is not damaged or does not jump out of position during installation.

    3. Connect the connector of the No. 1 crank position sensor.

  3. INSTALL SENSOR BRACKET (w/o Stop And Start System)

    1. Install the sensor bracket to the cylinder head cover sub-assembly with the nut.

      Момент затяжки
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }
  4. INSPECT FOR ENGINE OIL LEAK

  5. INSTALL NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

    Click here Нажмите здесь