ДАТЧИК ПОЛОЖЕНИЯ КОЛЕНЧАТОГО ВАЛА УСТАНОВКА

PROCEDURE

  1. INSTALL CRANK POSITION SENSOR

    1. Apply a light coat of engine oil to the O-ring of the crank position sensor.

      A012GP3C01
      *1 O-ring
      Note:

      If reusing the crank position sensor, be sure to inspect the O-ring.

    2. Install the crank position sensor with the bolt.

      A012GBN
      Момент затяжки
      8.8 N*m  { 90 kgf*cm, 78 in.*lbf }
      Note:
      • If a component has been dropped or subjected to a strong impact, replace it.

      • Make sure that the O-ring is not damaged or does not jump out of position during installation.

    3. Connect the wire harness clamp.

    4. Connect the connector to the wire harness bracket.

    5. Connect the connector from the crank position sensor.

  2. INSTALL GENERATOR ASSEMBLY

    Click hereНажмите здесь