СИСТЕМА МЕХАНИЧЕСКОЙ ТРАНСМИССИИ "MULTIMODE" КАЛИБРОВКА

  1. SYNCHRONIZATION POSITION CALIBRATION

    For smoother shifting, the TCM learns the synchronization position of the transaxle gears. Perform synchronization position calibration of the multi-mode manual transaxle while driving the vehicle after repairing system components.

    Tip:
    • If clutch fluid line parts are installed, bleed the air from the lines before performing initialization.

      Click hereНажмите здесь

    • When replacing the following parts, proceed with the operation in the order listed in the table below.

    Part Installed Operation Order See Procedure
    • Transaxle assembly

    • Transaxle parts (inside gear box)

    • TCM

    • Clutch actuator assembly

    • Clutch disc and clutch cover

    • Clutch release with bearing cylinder assembly

    • Flywheel

    • Crankshaft

    1. Initialization of multi-mode manual transaxle system

    [Tester display: Initialization of ECU]

    Нажмите здесь

    2. Learning of multi-mode manual transaxle system

    Нажмите здесь

    3. Synchronization position calibration See below
    • Shift and select actuator

    • Shift stroke sensor

    • Select stroke sensor

    1. Initialization of multi-mode manual transaxle system

    [Tester display: Initialization of transmission]

    Нажмите здесь

    2. Learning of multi-mode manual transaxle system

    Нажмите здесь

    3. Synchronization position calibration See below
    • Clutch stroke sensor

    1. Initialization of multi-mode manual transaxle system

    [Tester display: Initialization of clutch]

    Нажмите здесь

    2. Learning of multi-mode manual transaxle system

    Нажмите здесь

    Note:

    Do not clear (initialize) parts other than those specified in the "Part Installed" column in the table above.

    1. While driving the vehicle in M mode, shift up and down between 1st and 6th at the vehicle speeds specified below.

    2. Check that the gears shift smoothly.

      Table 1. Recommended Gear Shifting Speeds
      Gear Change Gear Position Vehicle Speed
      Up shift 1st → 2nd 25 to 40 km/h (15.5 to 24.9 mph)
      2nd → 3rd 47 to 68 km/h (29.2 to 42.3 mph)
      3rd → 4th 69 to 98 km/h (42.9 to 60.9 mph)
      4th → 5th 92 to 133 km/h (57.2 to 82.6 mph)
      5th → 6th 99 to 181 km/h (61.5 to 112.5 mph)
      Down shift 2nd → 1st 25 to 31 km/h (15.5 to 19.3 mph)
      Tip:
      • Leave an interval of more than 2 seconds between gear changes.

      • If there is a shock when changing gears after synchronization position calibration, perform synchronization position calibration again.