ДАТЧИК ВЫБОРА ПЕРЕДАЧ ПРОВЕРКА

PROCEDURE

  1. INSPECT SELECT STROKE SENSOR

    1. Measure the voltage between the terminals of the select stroke sensor connector (main).

      A012K5ZC03
      *a Main
      *b Select Stroke Sensor Arm
      *c 55°
      *d
      *e -55°
      1. Prepare 3 dry cell batteries (1.5 V) and 2 leads for connecting the batteries and the sensor.

      2. Connect the batteries in series.

      3. Connect the positive battery terminal to sensor terminal 4 (VCL1), and the negative battery terminal to sensor terminal 5 (E2L1).

      4. Measure the voltage according to the value(s) in the table below.

        Table 1. Standard Voltage (combined dry cell battery voltage of 4.5 V)
        Tester Connection

        Condition

        (Sensor Angle)

        Specified Condition
        6 (VSL1) - 5 (E2L1) 55° 3.6 to 4.5 V
        1.8 to 2.7 V
        -55° 0.27 to 0.63 V
        Table 2. Reference Voltage (combined dry cell battery voltage of 5.0 +/- 0.3 V)
        Tester Connection Sensor Angle Specified Condition
        6 (VSL1) - 5 (E2L1) 55° 4.0 to 5.0 V
        2.0 to 3.0 V
        -55° 0.3 to 0.7 V

        If the voltage is not as specified, replace the select stroke sensor.

    2. Measure the voltage between the terminals of the select stroke sensor connector (sub).

      A012K5ZC04
      *a Sub
      *b Select Stroke Sensor Arm
      *c 55°
      *d
      *e -55°
      1. Connect the positive battery terminal to sensor terminal 1 (VCL2) , and the negative battery terminal to sensor terminal 2 (E2L2).

      2. Measure the voltage according to the value(s) in the table below.

        Table 3. Standard Voltage (combined dry cell battery voltage of 4.5 V)
        Tester Connection

        Condition

        (Sensor Angle)

        Specified Condition
        3 (VSL2) - 2 (E2L2) 55° 3.6 to 4.5 V
        1.8 to 2.7 V
        -55° 0.27 to 0.63 V
        Table 4. Reference Voltage (combined dry cell battery voltage of 5.0 +/- 0.3 V)
        Tester Connection Sensor Angle Specified Condition
        3 (VSL2) - 2 (E2L2) 55° 4.0 to 5.0 V
        2.0 to 3.0 V
        -55° 0.3 to 0.7 V
        Note:
        • Do not apply more than 6 V.

        • Do not use a sensor which has been dropped.

        If the voltage is not as specified, replace the select stroke sensor.